ETC scales new heights with introduction of Prodigy P2 hoist

ETC is kicking off a new era in upper stage machinery with the introduction of the P2 hoist. Offering quick installation, easy operation, revolutionary features and affordable system expansion, P2 – the newest hoist in ETC’s Prodigy® family – can go where other rigging systems can’t.

The compact, 130-kilogram* P2 fixed-speed hoist has a 300-kilogram load capacity and can be used as a complete system by itself, or it can be combined with larger hoists in a hybrid system. Using five millimetre lift wire rope, it offers 15 metres of travel with up to eight lift lines. ETC’s QuickTouch® and Foundation® families of rigging controllers are feature rich, yet intuitive and uncomplicated, and work seamlessly with P2, and all of the hoist solutions from ETC Rigging.

The revolutionary features and capabilities that set ETC’s rigging products apart from others are at work in P2. The P2 hoist can be installed with or without ETC’s unique compression tube, is engineered to fit into the smallest spaces without adding lateral loads to buildings, so venues that aren’t able to use other larger hoists will finally be able to accessautomated rigging. Additionally, loft blocks can be positioned independent of the building’s structural mounting points, and allows users to support the attached load in a manner best fitting the load, instead of the building.

Safety is at the heart of P2, which includes load cell, and slack line detection. It also has a self-locking worm-gear system to prevent accidents. P2’s control electronics are built into the hoist, and incorporate hard-wired deadman and E-stop circuits.

Thanks to its advanced features and design, P2 is easier to install and commission than most other hoists on the market. “It takes very little time to get P2 in place,” says ETC Rigging Product Manager Nils Becker. “A pair of technicians could install six fully-commissioned hoists in a single day. That saves venues on installation costs, and results in less disruption to a production or event schedule.”

Adding additional hoists to a P2 system or upgrading existing hoists is also a simple process. “Rigging systems from other manufacturers often require significant control and wiring changes to add hoists, but ETC systems don’t,” explains European Rigging Sales Manager Enrico Nobile. “The faster installation and compatibility of our system components results in cost savings for our customers.”

For more information about P2 and all ETC Rigging systems, visit www.etcconnect.com.

 *Powerhead only